| Tech Data - Components: |
 | PLAN "A" INCLUDES 2 MODULES and a COMPACT DESIGN |
| |
-DESK DOES NOT INCLUDE GEAR SHOWN IN PICTURE- -SEE WORKSTATIONS- |
| |
|
| |
3/4" solid Red Oak side panels, and 1 1/2" thick desk nose. |
| |
Side leg profile finished with durable texture paint. |
| |
Side leg vent insert is made of fabric to reduce metal "ping or rattle". |
| |
Front and rear removeable panels are also open and covered in fabric to allow for sound pass through and reduce rattle. |
| |
Desk top surface is laminate to match other surfaces of the rack "Pod". |
| |
12ru of desk top rack space in each rack "Pod", |
| |
6ru of rack space in the lower front of each rack "Pod". |
| |
6ru or rack space in the rear lower section of each rack "Pod". |
| |
Heavy gauge steel foot assembly with heavy duty levelelers. |
| |
90% of the console parts are made from varying thicknesses of (green certified) MDF with melamine facing. |
| |
The desk surface is 1” thick and covered with a more durable “high pressure“ laminate . |
| |
The hardwoods components are sprayed with a pre-mixed “catalyzed” lacquer that cures faster and harder than older “one part” lacquers. |
| |
The thermal venting panels are fabricated using ˝” mdf, and covered with a polyester, “very open weave” speaker fabric. |
| |
|
| |
Compact and non acoustically-intrusive design |
| |
The hard Surfaces are minimized, and non parallel with other room surfaces. |
| |
Resonating and reflective surfaces minimized |
| |
Outstanding space and ergonomic planning. |
| |
NO Rear Surfaces that shot the sound back at the speakers. |
| |
NO Doors and latches that would eventually loosen and rattle. |
| |
NO perforated metal thermal venting, (Cloth venting) |
| |
NO equipment enclosures that leave no escape rout for the sound building inside the desk. |
| |
Rack design does not leave the engineer far out of the mix field during critical listening |
| |
|
| |
FOR MORE INFO WRITE TO: INFO@RAYAUDIO.COM |
